Hoover Press N Snap tool Professional button tool sets snaps and grommets

Description

INSTRUCTIONS FOR THE PRES-N-SNAP
INSTALLING FASTENERS
FIRST MAKE SURE THAT YOU HAVE THE CORRECT DIES FOR THE BRAND OF FASTENERS THAT YOU ARE USING. REMOVING AND INSTALLING DIES ON THE PRES-N-SNAP IS ACCOMPLISHED BY PULLING THE DIES OFF OF THE TOOL, OR PUSHING THE DIES ONTO THE TOOL.  IT HELPS TO ROTATE/TWIST THE DIES DURING INSTALLING AND THE REMOVAL OF DIES.  ALL DIES ARE HELD ONTO THE TOOL BY BLACK "0" RINGS. WITH THE HANDLE CLOSED, ADJUST THE END BOLT UNTIL THE DIES COME IN CONTACT,THEN BACK-OFF 1/2 TURN.  PLACE THE FASTENERS INTO THEIR CORRESPONDING DIES. LOCATE A PIECE OF SCRAP FABRIC AND FOLD TO THE SAME THICKNESS AS YOUR PROJECT.  PLACE THE FABRIC BETWEEN THE DIES AND PRESS/SQUEEZE THE HANDLE. FASTENERS SHOULD NOT ROTATE WHEN SET IN FABRIC.
CAUTION:   OVERTIGHTENING MAY CAUSE DISTORTION TO THE FASTENERS AND CAN DAMAGE THE DIES. IN THE EVENT THAT THE FASTENER ROTATES YOU MAY ADJUST THE END BOLT CLOCKWISE ON THE PRES-N-SNAP.  REMOVE THE M-2700 GRAY RING TO PREVENT CUTTING IT.  THEN CAREFULLY PRESS/SQUEEZE THE HANDLE BEING CERTAIN THAT THE FASTENER IS IN POSITION.
INSTALLING GROMMETS
FOR INSTALLING GROMMETS USE THE SAME PROCESS AS FOR INSTALLING FASTENERS. IF YOU ARE USING A STANDARD OR SPUR GROMMET YOU WILL NEED TO CUT/PIERCE A HOLE THROUGH ALL LAYERS OF MATERIAL AT ONE TIME.  PLACE THE GROMMET THROUGH THE HOLE AND THE WASHER ON IT.  WHILE HOLDING  IT IN ONE HAND USE THE OTHER HAND TO POSITION THE PRES-N-SNAP AND PRESS/SQUEEZE THE HANDLE.  THE GROMMET SITS ON THE ANVIL PORTION OF THE DIE SET  AND THE WASHER SITS ON THE ROLLING PORTION. IF YOU HAVE SELF-PIERCING GROMMET DIES DO NOT WASTE TIME CUTTING/PIERCING A HOLE IN THE FABRIC. THE GROMMET AND GROMMET DIE WILL CUT AND ROLL IN ONE ACTION SAVING YOU TIME AND MONEY.  WHEN PLACING THE GROMMET AND WASHER IN THE DIES,  IT HELPS TO PLACE THE WASHER FIRST THEN THE GROMMET.
Includes:
Button Die
Socket Die
Stud Die
Eyelet Die
#1 Plain Washer Grommet Dies